Device Parts - JTC OMNIBLEND V TM-800 Bedienungsanweisung

„Start up" continued"
Setting of the speeds
MED =
LOW =
HIGH =
35" =
60" =
90" =

4. Device parts

5. Cleaning
Cleaning is essential after every using of the appliance. It will be easier to clean if you do not
allow the remaining scraps of food to dry in the bowl, lid or on the knives. Stop the mixer and pull
the power plug.
•
Place a little warm water with mild detergent into container.
•
Place the lid on the container, switch the mixer on for approximately 10 seconds and
afterwards turn off the appliance.
•
The container must not be cleaned in the dishwasher. Because the water and salt in the
dishwasher will damage the seals and ball bearings of the knives. Also the container can
deform because of the high temperature.
•
Empty container, rinse and leave upturned to dry.
Note: The power unit is very strong, so you can remove most of the residual foods easily by
just using warm water and detergent.
Stand 12/2015 IH
Operating Instructions MIXER / BLENDER Modell TM 800
Medium speed
Low speed
High speed
Stored program with shut-off after 35 seconds.
Stored program with shut-off after 60 seconds.
Stored program with shut-off after 90 seconds.
1 LID INSERT (cap)
2 LID
3 CONTAINER
4 CUTTING UNIT
5 OVERLOAD RESET BUTTON
(on back/underside)
6 DRIVE SOCKET
7 MED BUTTON
8 LOW BUTTON
9 ON/OFF SWITCH
10 MOTOR BASE
11 HIGH BUTTON
12 PULSE BUTTON
13 Stored program with shut-off after 90
seconds
14 Stored program with shut-off after 60
seconds.
15 Stored program with shut-off after 35
seconds.
16
Mixing Rod
page 4/5