JTC OMNIBLEND V TM-800 Bedienungsanweisung Seite 8

3. Start up
•
Before the first use clean all parts throughly with a soft damp cloth and a mild commercial
detergent (see point 4 "Cleaning").
•
Plug the power plug into a suitable outlet.
•
Put the container with the contents on the motor base. Make sure that the cutting unit is
completely covered.
•
Small food additions or liquids, which are to be added during mixing, can be given by
removing of the cap for a short period of time.
•
First pour liquids and then give firm food into the container.
•
The mixer must be used with a minimum of liquid in the container, especially if you crush ice
cubes, but only in small cube sizes.
•
Fruit, vegetable, meat etc., must be cut in small pieces before mixing. The pieces should not
be bigger than 2 cm.
•
Do not fill up the container completely and add the food in small quantities.
•
Place the lid with the lid insert correctly on the container.
•
Switch on the mixer by pushing the ON/OFF switch (9)
•
Always start the mixer in the low level or with one of the keys "35" – "60" or "90".
•
The keys "35" - "60" and "90" are programmed for an automatic mixing process and also for
switching off.
Programming proceedings
•
The button 35 is for slow motion up to the high speed. After 35 seconds the mixer switches
off automatically.
•
The button 60 is for the slow motion up to high speed and the one more repetition. After 60
seconds the mixer switches off automatically.
•
The button 90 is for slow motion up to high speed and the four time repetition. After 90
seconds the mixer switches off automatically.
•
The HIGH, MEDIUM and LOW buttons have no automatic switching off. If you select one of
these buttons, the mixer will stay in operation for this speed. To turn off the mixer, it is
enough to press any button. You obtain the fastet speed, by keeping the pulse function
button pressed.
•
The power will be switch off automatically, if the motor is overloaded. For example: If
something blocks the cutting unit, the motor can be overheated. In this case pull the plug
from the socket and give the contents into another bowl. Allow the mixer to cool down. Press
the reset button (on back or on the underside, depending on model) to start again.
General notes:
Depending on the length of the mixing, the inside can heat up. To avoid add the contents of
the container should small amounts of ice.
With the plunger the ingredients will be pressed safely on the turning knives, in order to work
fast and efficiently.
When using the plunger, make sure the top is made of soft material. This means it may be
possible the top can deform under pressure.
The plunger should not be used forceful otherwise the turning knives can damage the
plunger.
To prevent that the BPA-free reservoir will be deformed do not operate longer than 90
seconds with hot products.
In operation can occur through the motor (carbon brushes) a slight odor. This is normal and
not a defect.
Stand 12/2015 IH
Operating Instructions MIXER / BLENDER Modell TM 800
page 3/5