JTC OMNIBLEND V TM-800 Bedienungsanweisung Seite 7

„General Information" continued"
•
Do not use the appliance outdoors in case of rain!
•
Before connecting the device, make sure that an Schuko socket is available (with ground)
and a 230 volt connection. Other types of current can lead to the device overheating.
•
Observe the accident prevention regulations and general safety rules applicable to the area
of application
•
Before first use clean the unit carefully.
•
Before cleaning the appliance, always pull the plug out from the socket.
•
The manufacturer / dealer can not be held responsible for damage caused by non-
compliance with this Instruction Manual. In addition, the safety of the appliance is then no
longer guaranteed.
•
In case of failure and/or malfunction, pull the plug from the outlet and contact your dealer.
They will carry out any repairs with original spare parts.
2. Safety Instructions
•
Always ensure that the container is properly seated in position and the container lid
(complete) is properly fitted and secured before switching on the blender, place hand on top
of lid when starting machine and during operation.
•
Do not use the appliance when the container is empty.
•
Do not use the appliance to crush big ice cubes or frozen foods.
•
The use of attachments, including container, not recommended by the manufacturer may
cause a risk of injury to persons.
•
Do not insert dry ingredients into the mixer before switching it on.
•
Container should not be more than 2/3 full while blending.
•
Take care if you blend hot liquids. Fill container only up to the maximum mark of 1 litre.
Always start motor on low speed or auto mode.
•
The lid with the lid insert must be on the container during operation.
•
Put your hand on the lid, when switching on and during operation.
•
Always start the mixer in the low stage or with one of the keys "35" – "60" or "90".
•
Never remove the lid from the container or the container from the motor base before the
knives have stopped completely.
•
Use the appliance only on a stable, flat and non-skidding surface.
•
The appliance may be connected to a grounded socket only. Do not connect any other
appliance to the same socket. The outlet must be easily accessible, so that the plug can
easily be removed in the case of an emergency.
•
Do not touch the cable and the plug with wet or moist hands.
•
The cable must not hang over table edges and/or sharp edges. It also must not come into
contact with the hot appliance surface or with water.
•
Regularly check the cable. If it is damaged, it must be exchanged by a qualified specialist.
•
Do not leave the mixer unattended while it is in use. Children are not able to realise dangers
when handling electronic appliances.
•
Do not move the appliance during working.
•
Be cautious with inserting, removing or cleaning the knife insert. The knives are sharp.
•
Do not let the appliance work, if the container is empty.
•
Before each cleaning session or repair, switch off the appliance. Then pull the power plug out
of the socket. The appliance should neither be cleaned in a jet of water nor with a high
pressure spray. The motor unit must not be immersed in water.
•
Never do attempt to repair the appliance by yourself. Repairs may only be undertaken by a
qualified specialist using original spare parts.
•
If you do not like to use the appliance for a longer time, then unplug and clean the appliance.
Stand 12/2015 IH
Operating Instructions MIXER / BLENDER Modell TM-800
page 2/5