Installation + Connection - V7 UPSSNMP1 Schnellinstallationsanleitung

Installation + Connection

1. Remove cover of intelligent slot on the back panel of UPS.
*Note: Make sure to retain the screws.
2. Slide the card into the slot and secure with the screws.
*Model May Vary
3. Plug the Ethernet cable into the RJ-45 port of the SNMP card.
Configuration
a. Install and start the SNMP Manager software (http://www.v7support.com/downloads).
b. Enter the IP address to search all SNMP devices on the network.
By default, the SNMP card will acquire an IP Address from DHCP. If there is no DHCP server on the network, the default settings are:
• IP address: 192.168.102.230
• Subnet mask: 255.255.255.0
• Gateway/Router: 192.168.102.1
The default value in the window list will search the same network as the current computer's IP address. For example, if the IP address of
the computer is "192.168.102.10", it will display "192.168.102" in the list when first starting SNMP Manager.
Please check the HELP file of the SNMP Manager software for more information.
Slide card into slot here