Ningbo XPB68-2000S Bedienungsanleitung Seite 9

 Cleaning after use will extend your washing machine. Before cleaning turn off the power switch and
disconnect the power cord from the electrical outlet.
Over Flow Lint Filter
 Remove the lint filter by pulling it forward.
 Wash away the lint stuck in the filter during overflowing.
 Re-install the lint filter: By first inserting its bottom section and then pushing the upper part firmly
into place.
 Avoid using excessive amounts of bleach, soap powder or detergent. Use the amount recommended
by the respective manufacturers.
 For your safety, ensure that the ground connection is correct.
 Never put your hands into the spin tub while it is operating.
 When washing, the water temperature should be below 50°C. This is to prevent the plastic
components from becoming deformed.
 Do not placed the washing machine close to heat-generating products such as gas cookers or
electric kettle.
 When cleaning the washing machine, try to use soft cloth. This will prevent damages to the surface
of the cabinet.

'Avoid placing a wet load on the control panel.
 Do not place the washing machine out door or damp area such as the bathroom.
There may be times when you suspect your washing machine requires maintenance. Before calling for a
service engineer, please check the following points, to save unnecessary cost. You may be pleasantly
surprised that an apparent malfunction can be easily rectified by following the chart below:
If your washing machine will not start, check whether:
 The hose circuit breaker is tripped or a fuse is blown.
 The cord is firmly connected to the power point or the power point is not switched on.
 Something is preventing the pulsator from rotating.
 The wash timer is set.
If the spin dryer will not operate, check whether:
 The inner lid and outer spin bowl-lids are closed.
 The spin dry timer is set.
If there is excessive noise, check whether:
 Something is touching the pulsator as it rotates.
 The machine is not placed on a level surface.
 The wash load in the spin bowl is excessively unbalanced during the spin cycle.
 An article is lodged between the spin bowl and tub.
Laundry Guide
Cleaning After Use
Points to Remember
Before You Call For Service