Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparing the Wash
The machine should be placed on flat ground.
Separate the laundry into different groups like: white clothes, colour cloths, delicates clothes, lint-
free and etc. Wash the laundry according to the washing guide.
Clothes with worn patches or tears should be mended first. Empty all pockets and close all
fasteners.
Prior to Wash
Remove the plastic spin mat from the spin tub.
Check that wash timer knob is set to position "O" and that the selector switch is set to "Wash".
Ensure that drain hose is placed flat on the ground.
Insert the power cord plug into the power point and switch on.
To Wash
Place the wash load and detergent in the wash tub.
Set the selector switch to "Wash" mode.
Turn the watertap on and fill the wash tub to the level recommended in the "Laundry Guide".
Set the wash timer to the wash period recommended in the laundry guide. Your machine will now
wash for the period selected. When the wash period expires, set the selector switch to the "Drain"
position to discharge the water.
To Rinse In The Wash Tub
Overflow Rinse
Set the water inlet knob to "Wash Tub".
Turn the water tap on.
When the rinse water becomes clear, turn off the water tap.
Set the selector switch to "DRAIN" position to discharge the water.
To Rinse In The Spin Tub
Spin Tub Rinse
Set the water inlet knob to "Spin Tub".
Turn the water tap on.
Set the selector switch the "DRAIN" position to discharge the water.
Spin Drying
To open the inner safety lid of the spin tub, lift up the outer spin cover, then lift up the safety
lid.
Transfer the wash load to the spin tub commencing with small articles. Ensure that the
clothes are evenly distributed.
Place the removable spin mat over the load to be dried and push lightly downward. (To
contain delicate articles within the spin tub).
Close the inner safety lid, then the spin cover.
Set the spin timer to the time recommended in the Laundry Guide. The spin tub will spin for
the time selected, the stop (at position"O")
Caution: Ensure that the spin tub completely stops before reaching in to remove the wash load.
Be especially careful of children.
To remove or reposition clothes during the spin dry cycle, open the spin cover and inner lids.
In this case, the spin tub will automatically stop as a brake is activated when the spin cover
is opened. To restart, close both lids. If required, reset the spin timer.
If there is any abnormal vibrating during spin-drying, turn off the spin timer and rearrange
the clothes inside the spin tub.
Simultaneous Washing and Spin Drying
Two motors are fitted to cover washing and spin-drying.
This arrangement enables spin drying of a previous wash load and washing of a new wash load to
be simultaneously effected.
set the controls for both "wash" and "spin" modes (see "To Wash" and "Spin Drying").
Clearing the Tub
Set the selector switch knob to "DRAIN" mode.
Machine is now empty.
Set the selector switch knob to "WASH" mode.
Switch off the electricity at the power point.
Operating Instructions
Werbung
Inhaltsverzeichnis
