Maintenance; Disposal - Herth+Buss Claw 400 Bedienhinweis

Operating Instruction
Note:
1. Do not input voltage to the output plugs of
the Current Probe.
2. For DC current measurements, the display
of the multimeter will also indicate the
measured current's direction. A positive
reading (negative sign „-" doesn't appear)
indicates that the current direction is from
the Current Probe's front to its back.
Tip: Current direction is the opposite of
electron flow direction.
3. Each time after you finish a measurement
and remove the jaws from the conductor
under test, there may be a residual read-
ing on the display. This reading must be
subtracted from the measurement you
just performed.

8.0 Maintenance

Except replacing battery, never attempt to
repair or service the Current Probe unless
you are qualified to do so and have the rel-
evant calibration, performance test, and ser-
vice instructions.
The Current Probe should be stored in dry
place when not in use. Don't store it in in-
tense electromagnetic field environment.
Periodically wipe the case with a damp cloth
and detergent, do not use abrasives or sol-
vents.
lf you don't use the Current Probe for a Iong
time, remove the battery from it.
15

9.0 Disposal

lf you at some point intend to dis-
pose of this article, then please
keep in mind that many of its com-
ponents consist of valuable materi-
als, which can be recycled. Please do not
discharge it in the garbage bin, but check
with your local council for recycling facilities
in your area.
Note:
1. This manual is subject to change without
notice.
2. Our company will not take the other re-
sponsibilities for any loss.
3. The contents of this manual can not be
used as the reason to use the Current
Probe for any special application.
95980785
EN