Conceptronic C300EXi Benutzerhandbuch Seite 15

ENGLISH
5.2 WPS – Pin Code connection
When your router or access point does not have a push button, you can also connect with WPS with a Pin
Code.
The Wireless Utility can work in "Enrollee" or "Registrar" mode:
- When "Enrollee" is selected, the Wireless Utility will generate a Pin Code which must be
entered in the WPS configuration of your router or access point.
- When "Registrar" mode is selected, you can enter a Pin Code in the Wireless Utility. This
mode is needed when your router or access point provides a Pin Code which must be used for
the wireless connection.
Activate the PIN WPS connection on your router or access point.
Select the correct "Config Mode" in the Wireless Utility, according to the information above.
Click the "PIN" button in the Wireless Utility.
You can see the WPS activity at the bottom of the window:
When the connection is established, the message "WPS status is connected successfully" will be shown:
You are now connected to the wireless network. The Wireless Utility will indicate the signal strength in
your system tray:
15