S&P DHUM-12 E Bedienungsanleitung Seite 20

Note: The device incorporates a delay system which causes it to wait for approximately 3
minutes before starting to operate, in order to protect the compressor. At the end of the delay
period, it starts working automatically and the indicator light
• Using the button
ne, a comfortable relative humidity level in a room at a temperature of 22ºC would be in the
range 55-60 %HR.
Once the required relative humidity has been selected, the relative humidity display indicator
(Fig. 2(h)) ceases to blink and indicates the current relative humidity in the room. If it is higher
than the required humidity, the device commences its dehumidification function. If it is lower,
the device remains in a waiting state (functioning only as a fan) with the indicator light
blinking.
CO 30 35
CO: Continuous operation mode.
AU: Automatic operation mode.
Continuous operation mode (CO)
If the user selects this option, the humidifier remains in operation permanently, regardless of
the level of humidity in the room. Use of this mode is recommended when the level of humidity
in the room is high.
Automatic operation mode (AU)
If the user selects this option, the dehumidifier self-regulates automatically depending on the
temperature in the room and the following operating settings.
Room temperature (TºC)
TºC < 5ºC
5ºC < TºC < 20ºC
20ºC < TºC < 27ºC
TºC > 27ºC
• By using the speed selector
Fast Speed: Hi
Slow Speed: Low
Timer operation
By using the button
the end of the programmed period the device stops completely.
, select the required relative humidity for the room. By way of a guideli-
...
40 80 85
, you can set the speed of the fan:
, the user can program a period of operation between 1h and 24h. At
ceases to blink.
90 AU
Operating settings
Compressor Stop
20
60%
55%
50%