Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
To set the stamp wheels Fig.
A
Press the handle
travel, then while still holding it.
Press bolt
B
at the bottom end of the handle.
Guide the handle
snaps into a depression.
You will be able to move the stamp wheels
D
freely with the stylus
You can lower the preceding zeros!
Example:
49
Turn the stamp wheel
digit position "0".
C
Using stylus
rotate and push down on
D
stamp wheel
through a half digit position
until it sinks below print height.
To return to the print position, simply push
B
bolt
in the middle of the handle
Any wheel which has been 'sunk' will auto-
matically be brought to print height as the
numbering sequence progresses. 'Sunk' wheels
can be brought into play by simply rotating
them further (ie. push towards figure 1.).
To insert the inkpad Fig.
Handle with caution to avoid dirt from ink!
A
Press the handle
travel, then, while still holding it.
B
Press the button
continue to hold it.
Allow the handle
A
handle locks in place.
1
2
+
to the bottom of its
A
upwards until the handle
C
.
instead of
000049
D
C
with stylus
A
.
1
3
+
to the bottom of its
on the front plate and
to move upwards until the
Unpack the inkpad carefully.
Insert the inkpad in the slot
up to the limit stop and fasten with the
screws of the inkpad.
Resting the back of the ink pad inside the
pad cradle slide the pad into the slot
the stamp.
In order to return to the starting position,
hold handle
To change the numbering actions Fig.
Actions
0
to
1
2
Loosen the screw
Raise the automatic
at the desired interval.
Tighten the screw
To park the stamp Fig.
To prolong the life of the inkpad,
park the stamp!
Press the bolt
handle and then keep pressing it.
Gently push handle
stamp clicks & locks in a raised position.
To return to the starting position, hold
handle
A
and push bolt
The same number is stamped every time.
Number increases after each stamping
process.
Number increases after every 2
stamping process.
etc.
F
.
H
and place the slide
F
.
B
at the bottom end of the
A
downwards until the
A
and push bolt
GB
E
of the stamp
E
of
B
in the middle.
4
nd
G
5
B
in the middle.
Werbung
