Frequently Asked Questions - Jabra GN 9120 Bedienungsanleitung

Making telephone calls:
To make a telephone call:
1. Remove the headset from the base unit. The link will be established
and the on-line indicator will light.
2. Lift the telephone's handset and listen for a dial tone in your head-
set.
3. Dial the desired number.
To end the call, simply lower your telephone's handset to its
cradle.
Note: If you connect the telephone connection cord to your tele-
phone's headset socket instead of the handset socket, this will enable
the telephone's line button. You can now answer and end calls by
pressing the line button instead of using the handset.
Answering telephone calls using the GN 1000 RHL
(Remote Handset Lifter):
You may purchase a GN 1000 RHL as an accessory,
which lets you answer and end telephone calls while
away from your desk. Please contact your vendor or
visit www.gnnetcom.com for further information.
To answer a call using the GN 1000 RHL or electronic
hook switch functionality:
1. Remove the headset from the base unit when you
receive a call. The link will be established and the on-line indicator (1a) on the front
of the base unit will begin to fl ash.
Note: If you are already wearing the headset, simply press the multifunction button (2d)
on the headset momentarily to answer the incoming call.
To end the call, press the multifunction button for 2 seconds or place the headset in
the base unit.
12
GN9120_contents_RC_new2_EU.indd 12-13
Making telephone calls using the GN 1000 RHL or electronic hook switch functionality:
To make a telephone call using the GN 1000 RHL:
1. Remove the headset from the base unit. The link will be established and the on-line
indicator (1a) on the front of the base unit will begin to fl ash.
2. Dial the desired number.
To end the call, press the multifunction button for 2 seconds or place the headset in
the base unit.
Note: The connection (8) cord must be connected to your telephone's handset socket
in order for the GN 1000 RHL to function.

Frequently Asked Questions

I do not hear a dial tone.
• Check that all the cords and plugs are connected correctly.
• Check that the power adapter is plugged in and has power.
• Check that the on-line indicator is lit. If it is not, place the headset in the base unit and
take it out again.
• Check that the battery is fully charged. If the battery is fully charged, the battery
charging indicator on the base unit will light when the headset is placed correctly in
the base unit.
I hear beeps in my headset.
• A beep every 15 seconds means that the mute function is on.
• A beep every 10 seconds means that you are out of range
(up to 150 m, depending on environment) of the headset's
base unit. Move closer to the base unit.
• A beep every 20 seconds means that the battery charge is
low and needs to be recharged.
The person I am talking to has diffi culties hearing me.
• Check that the mute function is off.
• Readjust the microphone volume.
• Check the position of the boomarm and make sure that the microphone is placed as
close as possible to your mouth.
150 m
13
09-10-2003, 15:29:34