IntesisHome DK-RC-WIFI-1 Installationsanleitung Seite 5

IntesisHome DK-RC-WIFI-1
®
7. Close the IntesisHome's and Daikin's lid again.
8. Plug the Daikin system to mains electricity.
If connection with the Daikin system has been successful, IntesisHome device LED will start
blinking Green and then will change to steady Green.
9. Connect the external antenna into the antenna connector.
10. Place the antenna preferably in a vertical position and pointing directly to the Wi-Fi Router or
Access Point (AP). See section 3.
2.2 Without Control Panel
This method assumes that you want to control the Daikin system through IntesisHome
exclusively.
1. Unplug the Daikin system from mains electricity.
2. Open the top lid of the IntesisHome device and remove IntesisHome's Top Hole cover.
3. Connect one end of Daikin's bus cable into IntesisHome device K1 connector.
4. Connect the other end of Daikin's bus cable into Daikin's Indoor Unit P1P2 connector or Remote
Control Wiring (see www.intesishome.com/docs/DK-RC-WIFI-1-Install_sketch.pdf for more
information).
5. Configure the IntesisHome switches
6. Close the IntesisHome's and Daikin's lid again..
7. Plug the Daikin system to mains electricity.
If connection with the Daikin system has been successful, IntesisHome device LED will start
blinking Green and then will change to steady Green.
8. Connect the external antenna into the antenna connector.
9. Place the antenna preferably in a vertical position and pointing directly to the Wi-Fi Router or
Access Point (AP). See section 3.
K1
(www.intesishome.com/docs/DK-RC-WIFI-1-Install_sketch.pdf)
3 m
Max. 500 m
Wi-Fi Router or
Access Point
P1
P2
INSTALLATION GUIDE
EN
5