Virax HP PRO Benutzerhandbuch Seite 27

USE - Fig. 20 to 25
Fig. 20 – ACTIVATE THE ON / OFF SWITCH
Fig. 21 –
Before putting the device under pressure, hold the lance firmly or make sure that the
handle of the gun is not activated: The high pressure jet generates recoil and can turn the lance
into a dangerous object.
Always direct the jet towards the ground when starting up!
Fig. 22 – MULTIJET Lance: ADJUSTMENT OF THE ANGLE of the high pressure jet.
Tightening
Untightening
 WIDE jets (25 to 45 ) are recommended
to clean vehicles: quicker & - "aggressive".
 The pen jet (0 ) to remove dirt.
Fig. 23 – MULTIJET lance: Switch to LOW PRESSURE for use of detergent.
The detergent is sucked in by Venturi effect by means of an injector
placed at the high pressure outlet:
The release and use of the detergent is only possible
at LOW PRESSURE!
PUSH the lance head FORWARD=
Fig. 24 – Locking of the gun trigger
If, to shut down the electric supply or for whatever other reason, you have to put the gun down
while the equipment is switched on and under pressure, make sure that the trigger of the gun
is locked by means of the RED lever placed behing the trigger.
Fig. 25 – REMINDER OF SAFETY INSTRUCTIONS during use
Do not direct the high pressure jet towards a power supply or an
electrical device which is switched on
= INCREASES the angle (up to 45 ).
= DECREASES the angle (down to 0 ).
LOW PRESSURE
Do not direct the jet towards living beings.
If necessary, mark off a protected area of use.
English
.
(including the cleaner-unclogger!).
27