Specifiche Tecniche - Verse EDGE 500 Bedienungsanleitung

EDGE
LOW FREQUENCY SECTION
HIGH FREQUENCY SECTION
ACOUSTIC RESPONSE
CONSTRUCTION
AMPLIFIER SECTION
CONTROLS
DISPLAY LEDs
CONNECTORS
PHYSICAL FEATURES
500 - Manuale Utente

SPECIFICHE TECNICHE

Number of Drivers 2
Woofer Diameter 8 inch / 209 mm
Voice Coil Diameter 2 inch / 50 mm
Winding Material Copper
Magnet Type Ferrite
Number of Drivers 1
Voice Coil Diameter 1.4 inch / 36 mm
Winding Material Aluminium
Throat Diameter 1 inch / 25 mm
Magnet Tipe Ferrite
Horn Design Elliptical Wave Guide
Horn Coverage 90° Horizontal - 60° Vertical
Maximum SPL Peak @1m 127 dB
Frequency Response
Crossover frequency 2400Hz
Material Polypropylene – Composite molded high impact enclosure
Handles 2 on the sides – 1 on the top
1 hole on the bottom (for speaker stand fitting).
Coupling 2 M8 screw mounting holes on the sides
1 hook on the rear (for speaker hanging)
Protections Perforated and painted metal grid
Total Amplifier Power 415W - EIAJ (1kHz, 1% THD)
Max LF output power 350 W
Max HF output power 65 W
Distorsion <0.05% (THD, DIM, SMPTE)
Input sensitivity
Line Input impedance
Active protective circuitry Thermal, overload, short circuit, soft clip and voltage limiters
HF protection ptc
Subsonic filter Yes
Gain
Dynamic loudness
High pass filter
ON (Green Led)
Overload / short circuit protection (Red Led)
Thermal protection (Red Led)
Compressor high (Red Led)
Compressor low (Red Led)
Signal (Green Led)
Line Input:
Link:
AC Connector: 3 pin IEC 250 VAC with fuse
Dimensions (W x H x D) 355 x 635 x 420
Weight 16 Kg
IT - 13
58 Hz ÷ 20 kHz
0 dBu
30 kOhms (balanced) – 15kOhms (unbalanced)
Female XLR
Male XLR
mm