Meta System Meta Voice Installationsanleitung Seite 11

Also try not to fi t the microphone close to the air vents as the fl ow of air could be picked
up as background noise.
Before fi xing the microphone in its permanent position, point it towards the driver's
mouth and then fasten the cable into the clip of the support.
It is always advisable to proceed with a functional test.
If functions testing fails to give satisfactory results, change the position of the micro-
phone and test again.
WHERE TO FIT THE LED SWITCH
4
The Led-Switch should be fi tted using the double-sided adhesive tape supplied (alrea-
dy stuck onto the base) in a place that is in clear view of the driver and is easily reached
by him.
Clean the surface well to remove any dust or dirt that could prevent it from sticking.
The switch should not be fi tted onto surfaces that are not perfectly smooth or are cur-
ved as it could come away in future.
Fit the switch at a minimum ambient temperature of 20 °C.
Run the connection wire through the dashboard taking care not to damage it when
refi tting it.
Always fi nish fi tting the switch before connecting it up to the Bluetooth control unit.
11