Sunred GH12 BLACK Handbuch Seite 10

STEP 3
3.1. Put the tank housing through the post.
STEP 4
4-1. Fit the gas steel pipe nut into the burner gas inlet connector.
● Secure the reflector support bolts on the flame screen cap with
4 pcs 60 mm length pins & 4 pcs Ø8 mm washers.
● Connect the pins & washers to the flame screen.
● Tighten the pins.
4-2. Tighten the gas steel pipe nut and gas inlet thread.
● Put the burner with steel pipe onto the post.
● Fix the burner base to the post by 4 pcs M6 x 10 mm bolts.
STEP 5
5-1. Check whether the connection of vertical post and burner are assembled as
instruction, and all bolts and nuts are tightened.
5-2. Put the flat washer onto the top of each burner/reflector support bolts
(M8 thread).
www.sunred.nl