Package Contents; Explanation Of The Symbols; Safety Instructions; Installation - Sygonix 420 TVL Bedienungsanleitung

Operating instructions
GB
CCD Colour Camera, 420 TVL, 4 - 9 mm
Use in accordance with manufacturer's instructions
This camera is intended for installation in, monitoring and protecting, se-
cluded or critical areas (e.g. entrance areas, surveillance of underground car
parks and the like).
The product is designed for use indoors and outdoors (IP65).
The camera is only intended to be used with a stabilised direct current of
12 V/DC.
Please bear in mind that it is prohibited by law to observe strangers with a
camera without their knowledge and consent. Observe the rules and regu-
lations of the country where you are using the camera.
Any other use than that described above may damage the product. More-
over, this may give rise to hazards such as short-circuiting, fi re, electric
shock, etc. No part of the product may be modifi ed or converted!
The safety instructions must be observed at all times!
This product complies with the applicable National and European require-
ments.
All names of companies and products are the trademarks of the respective
owner. All rights reserved.

Package Contents

• Colour Camera
• Mounting material (screws/wall plugs)
• Operating Instructions

Explanation of the Symbols

This symbol indicates specifi c risks associated with handling, func-
tion and use.
The "arrow" symbol indicates special tips and operating information.

Safety Instructions

The warranty will be void in the event of damage caused by
failure to observe these safety instructions! We do not assume
any liability for any consequential damage!
Nor do we assume liability for damage to property or personal
injury caused by improper use or failure to observe the safety
instructions. In such cases the warranty will be null and void.
• The unauthorised conversion and/or modifi cation of the product
is inadmissible because of safety and approval reasons (CE). Never
dismantle the product.
• The camera is only intended to be used with a stabilised direct
current of 12 V/DC. The inner contact of the round plug should be
Plus/"+", the outer contact Minus/"-".
• The product is not a toy and must be kept out of the reach of chil-
dren. It should be operated out of the reach of children.
• The use of the surveillance camera system does not replace the
personal supervision of children, or people who require special as-
sistance, but only serves as a support to this supervision.
• The camera is suitable for use in indoor and outdoor areas (IP65).
However, it must never be used in or under water, as this will de-
stroy it.
The home technology brand for the entire house. More information at www.sygonix.com
• The plugs on the camera's connection cable are not waterproof or
watertight and, therefore, must be placed in a dry indoor area.
• The camera should not be exposed to extreme temperatures, di-
rect sunlight, strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not pinched or damaged by
sharp edges.
• Do not leave packing materials unattended. They may become
dangerous playthings for children.
• Handle the product with care, it can be damaged by impacts,
blows, or accidental drops, even from a low height.
• If the camera is used with other devices e.g. a monitor, the operat-
ing instructions and safety notices for the devices connected must
be followed.
• It can be assumed that safe operation is no longer possible if:
- the device is visibly damaged,
- the device no longer works
- the device has been stored under adverse conditions.
- it was exposed to heavy loads during transport
• In commercial institutions, the accident prevention regulations of
the Employer's Liability Insurance Association for Electrical Sys-
tems and Operating Materials are to be observed.
• Ensure that all the electrical connections and connection cables
between the different devices and any extension cables comply
with the regulations and comply with the operating instructions.
• Disconnect the power supply from the camera, if it is not to be
used for a while (e.g. for storage).
• If you have any questions, which are not answered in this man-
ual, please contact our technical service or another specialist.

Installation

For outdoor use, we recommend choosing a location that is protected
from rainfall (e.g. under the eaves), to prevent droplet formation on
the camera's front screen, which will cause a distorted and un-usable
image.
The camera is equipped with a pre-mounted wall bracket. This needs to be
screwed in place, at a suitable position using the four screws. Use suitable
screws and wall plugs, depending on the surface.
Make sure when screwing into place or when drilling holes that no
cables or wires are damaged.
If the connection cable is to be laid so it is hidden, a correspondingly large
hole has to be drilled underneath the wall bracket, so the plug can be
passed through. The wall bracket will then cover this opening and protect
the cable from intentional damage.
Alternatively, the cable can be lead to the outside. For this purpose, use
the rubber plug on the bottom of the wall bracket. Protect the cable with a
suitable cable conduit or similar.
The connection plugs are not waterproof and should be kept in-
doors, otherwise they could corrode.
Attach the camera in the desired position and fi x it to the wall bracket using
the screws.
The camera should not be pointed directly at bright sources of light or the
sun, since the image will be overexposed.