Operation; Maintenance - Ribimex RibiTech IW1000 Bedienungs- Und Wartungsanleitung

INSERTING AND REMOVING A SOCKET
- To install a socket on the anvil (Fig B):
Align the hole of the socket with the anvil and push
down firmly.
Ensure it is centered and properly fixed.
- To remove a socket from the anvil :
Pull socket out firmly
SWITCH (Fig. C)
To operate tool, press on switch (2) (Fig. A ).
To stop tool, release switch.
The switch has 2 positions :
- on top: (R) to reverse (go counter-clockwise)
- on bottom: (F) to go forward (clockwise)
V. OPERATION
Intended use
- The product is intended for domestic use.
- The product is intended for forward and reverse screwing (e.g. changing wheels, exhaust pipe,
shock absorbers, on lawnmowers or small motors)

Operation:

1. Connect product to a power source (refer to characteristics on product).
2. Wear appropriate protective equipment.
3. Prepare material for work
4. Secure material if necessary.
Do not use your own weight or body to hold material.
5. Firmly hold tool with both hands. Always maintain a balanced and secure position.
6. Place socket on material. Do not make sudden movements.
7. Press on rocker switch [(R) or (F)] to start operation.
To stop tool, release rocker switch.
8. Once work is finished, stop product by releasing the switch.
Note: do not put down product until chuck has completely stopped rotating.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its
power source.

MAINTENANCE

Clean plastic parts with a soft clean cloth.
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not put or immerse product in water or any other liquid.
Clean ventilation holes with a soft brush.
STORAGE
Product must be stored in a dry location. Always lock up product and keep out of reach of children
Fig. B
Fig. C