Callaway Micro Bedienungsanleitung Seite 9

PRISM MODE DIAGRAM
NOTE:
The closer you are to the Pin, the more accurately you will
have to aim the Rangefinder in the direction of the built in reflector.
4. Scanning - To measure distances to multiple targets in succession,
HOLD the Power Button. Measurements will change as you scan
the landscape and change targets. Scanning should only be used
while in Laser or Pin Mode.
NOTE:
While scanning in P.A.T. Mode, the measurement will only
change when a shorter distance is measured. This is useful when
measuring the distance to a flagstick when there are trees or other
objects in the background.
5. Unit of Measure - To change the unit of measure from Yards ("Y")
to Meters, PRESS Power Button to power on, then HOLD Mode
Button (M). The unit of measure is indicated by a "Y" or "M"
shown directly to the right of the distance displayed.
HOW TO USE
8
Reflector located in
Middle of Pin
Reflector located on
Top of Pin