Switching On/Off - Cocraft PRO D50 Bedienungsanleitung

Switching on/off

Press [ ] to switch the receiver on. The receiver will emit an audible signal and all
level indicators (2, 3 and 4) will flash once. Press again to turn the receiver off.
Centre locating slot
The laser line height can be marked at the centre locating slot (11) when the laser line
passes through the centre of the receiving window. The laser receiving slot is located
32 mm from the top edge of the laser receiver.
Centre indication
• Press [ ] to select the level of precision for centre indication, normal or high.
• The default setting is normal when the receiver is turned on.
• The LED indicator (6) will light when the high setting is selected.
Detection
Note:
• Make sure that the laser you are using with the receiver is set to Outdoor
or Pulse mode.
• Fix the receiver in the horizontal or vertical position depending on the type of
laser line you are measuring, horizontal or vertical. Use the vials (1 or 8) to level
the receiver to true vertical or horizontal.
Directional indication
The corresponding LED indicator (2, 3 or 4) will light in response to the position that
the laser line passes through the laser receiving window. The laser line can also use
an audible signal for indicating the position of the laser line depending on whether
the buzzer is set to on or off. See the table below.
Directional The upper red indi-
cator lights up.
indicators
Move the detector
Horizontal
detection downwards.
Vertical Move the receiver
detection to the right.
Buzzer B-B-B-B-B (low
frequency signal).
The blue centre line
indicator lights up.
The laser line is centred
onto the central detection
line/locating slot.
The laser line is centred
onto the central detection
line/locating slot.
B----------
(steady signal).
4
The lower red
indicator lights up.
Move the detector
upwards.
Move the receiver
to the left.
BBBBBBBB (high
frequency signal).