Quax TRENDY Handbuch Seite 39

TRENDY
54 01 41xx
5. Assembling the bench
Needed parts : the leg frame from step 3, both end panels (now left and right) 2L and 2R, one side 1, one
longeron 8, both bottom panels 4 and the bottom 3
Step 1 : Use both end panels 2L and 2R, the side 1, eight wooden dowels A, eight connectors J, two con-
nectors G, the longeron 8 and two eccentrics H
Tighten two connectors (J) into the holes at the bottom on the inside of the side (1). Push two wooden dow-
els (A) in the provided holes on the ends of the side. Tighten two connectors (J) into the holes at the bottom
on the inside of the end panels (2L and 2R). Tighten one connector (G) into the holes at the bottom on the
inside of the end panels (2L and 2R). Push two wooden dowels (A) in the provided holes on the ends of
the longeron (8). Push two eccentrics (H) in the provided holes on the inside of the longeron. Tighten two
connectors (J) into the holes on the innerside of the longeron.
Step 2 : Use the side 1 and the longeron 8 of step 1, both bottom panels 4 and four eccentrics K
Push two eccentrics (K) in the provided drillings at the bottom of the bottom panels (4). Push the side (1)
with its connectors into the holes and over the wooden dowels in the bottom panels and tighten the eccen-
trics. Push the longeron (8) with its connectors into the holes and over the wooden dowels of the bottom
panels and tighten the eccentrics.
Omvormbaar bed 120x60 cm
Konvertierbar Bett 120x60 cm
Lit convertible 120x60 cm
Convertible bed 120x60 cm
Quax
First dreams
®
First steps
39