Battery Replacement; Power Supply - Rebell SC2060S Benutzerhandbuch

Variable ERROR
Can't Solve Error
Insufficient
MEM Error
Time Out Error
The error messages can be eliminated by pressing [◄] or [►] to search for and
correct the wrong submission, or pressing [AC] to cancel the entire calculation,
or pressing [ON] to restart the calculator.

Battery replacement

If the displayed becomes dark or dim, replace the battery with new ones
according to the following procedure.
Battery: CR2032 x 1
1. Turn off the calculator.
2. Remove the battery cover.
3. Replace the batteries. (+ side must be up).
4. Push in the battery cover.
5. After replacing the batteries, press keys in the following order: [ON][2ND][9]
(CLR) [3] (ALL) [=] (YES) [AC]. Be sure to perform this operation!

Power supply

Built-in solar cell and Lithium metal button cell battery CR2032 (1x).
Care / Maintenance
• Do not bend or twist the calculator.
• Avoid contact of the calculator with water or other liquid.
• Do not expose it to any strong impact, shock and vibration.
• Use a soft, dry cloth to clean the calculator.
• Do not leave a dead battery in the device. It may leak electrolyte and cause
damage to the calculator.
After use, this product should not be disposed of along with other household waste. Pass the
used product to a designated collection point for the recycling of electrical and electronic equip-
ment. For more information please contact your local municipal or city office or a company
engaged in the collection and transport of waste or the shop where the product was purchased.
© MORAVIA Europe, spol.s r.o. All rights reserved.
The information contained herein is subject to change without notice.
MORAVIA Europe, spol.s r.o. assumes no responsibility for technical or editorial errors or omi-
ssions contained herein that may occur. Reproduction, adaptation or translation of this manual
without prior written permission of MORAVIA Europe, spol.s r.o. is prohibited.
Printed in China.
Manufacturer / Importer: MORAVIA Europe, spol.s r.o., Olomoucká 83, 627 00 Brno, Czech
Republic
(1) You did not determine a variable of the root and the X
variable is missing in the equation that you entered.
(2) The variable of the root that you specified is not
included in the entered equation.
(1) The calculator was unable to find solution.
(1) Insufficient memory for storing the value or performing
calculation.
(1) The existing calculation of derivation or integrals will
be terminated without fulfilling the final condition.
13–EN