Rebell SC2060S Benutzerhandbuch Seite 29

0≤ n < 1 x 10
nCr
1≤ n!/r!< 1x10
POL(x,y) |x|, |y| ≤ 9.999999999x10
REC(r,θ) 0≤ r ≤9.999999999x10
θ: same as sinx
DMS(° ' ") |a|, b, c < 1 x 10
0 ≤ b, c
DMS ← ° ' " |x| < 1 x 10
Decimal ↔ Sexagesimal Conversions
0°0'0" ≤ |x| ≤ 9999999°59'59"
x>0 : –1x10
x
y
x=0 : y>0
x<0 : y=n,
However: –1x10
√y y>0 : x≠0, –1 x 10
x
y=0 : x>0
y<0 : x=2n+1,
However: –1x10
Total of integer, numerator, and denominator must be 10 digits
a /
b
c
or less (including division marks).
RanInt(a,b) a<b; |a|, |b|< 1 x 10
Error messages
An error message appears on the display if the calculations cannot continue in
the following cases:
Math ERROR
Syntax ERROR
Stack ERROR
Argument ERROR (1) There is a problem in the function argument that you
Dimension ERROR (1) Matrix/vectors were entered without specifying
, 0 ≤ r ≤ n (n, r are integers)
10
or 1≤ n!/(n–r)!< 1x10
100
≤ 9.999999999x10
100
100
<ylogx<100
100
(m, n are integers)
< ylog|x|<100
100
<1/x logy<100
100
(m≠0; m, n are integers)
<1/x log|y|<100
100
, b–a< 1 x 10
10
(1) If dividing by zero.
(2) If inserting values that exceed the maximum range
of the calculator for calculation.
(3) If the result of the calculated function exceeds
capacity.
(4) If the entered function argument is out of a valid range.
(1) Incorrect submission, uncomplying syntax.
(2) If an uncomplying argument has been entered in
the order.
(1) If the numerical value or operand value exceeded
a permitted range (stack overflow).
(2) If the [(] button is used more than 25x in one expre-
ssion in the linear mode.
want to calculate.
dimension.
12–EN
100
99
99
99
10