Battery Installation - Callaway 300LaserRangefinder Bedienungsanleitung

INCLUDES
A. CR2 - 3VOLT LITHIUM BATTERY
B. Carry Case
C. Cleaning Cloth
D. Lance Strap

BATTERY INSTALLATION

The Callaway 300 uses a replaceable CR2 3-volt lithium battery. To
install, remove the battery cap located below the Eye Piece. Insert
battery negative end first (flat end) and close battery cap.
1. Lift hatch tab.
2.
Turn counterclockwise to open.
3. Insert battery into chamber (negative end first).
4. Replace battery cap and tighten by turning clockwise.
NOTE: If the Low Battery Icon is present on LCD display, there are
approximately 200 ranges left until the battery is completely drained.
The Low Battery Icon will flash if the battery life is very low. In this
case, the battery needs to be replaced before next use.
ENGLISH 3