Acoustic Signals - AEG FAV55VI1P Benutzerinformation

2. Press .
• The indicators
and
• The indicator
flash.
• The display shows the current
setting: e.g.
– The levels of rinse aid are
from 0A to 6A.
– Level 0 = no rinse aid is
released.
3. Press again and again to change
the setting.
4. Press the on/off button to confirm
the setting.
6.4 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If you are using multi-
tabs containing rinse aid and you are
satisfied with the drying result, you can
deactivate the notification for refilling
rinse aid. However, we recommend that
you always use rinse aid for best drying
performance.
If you use standard detergent or multi-
tablets without rinse aid, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and start to flash and the
display is blank.
2. Press
.
, , ,
go off.
continues to
= level 4.
and until
, , , ,
• The indicators
and
• The indicator
flash.
• The display shows the current
setting: = the rinse aid empty
notification is activated (factory
setting).
3. Press to change the setting.
= the rinse aid empty notification is
deactivated.
4. Press the on/off button to confirm
the setting.

6.5 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
the indicators
and start to flash and the
display is blank.
2. Press
• The indicators
and
• The indicator
flash.
• The display shows the current
setting:
3. Press to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm
the setting.
ENGLISH 11
, , ,
go off.
continues to
and until
, , , ,
, , ,
go off.
continues to
= Acoustic signal off.