Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6
www.electrolux.com
5. CONTROLS
The hood is fitted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit's front panel:
1 1
1
Motor ON/OFF button
By pressing the button, the hood starts
at speed 1.
Pressing the button (OFF) while the
hood is in function turns the latter off.
2
Speed increase button
By pressing the button, the hood starts
at speed 1.
Pressing the button (while the hood is
on) modifies the motor speed:
Speed 1: the number "1" appears on
the display
Speed 2: the number "2" appears on
the display
Speed 3: the number "3" appears on
the display
High-speed: the number "4" appears
(flashing) on the display
The high-speed function is regulated by
a timer. The standard time setting is 5',
at the end of which the hood adjusts to
speed 2.
Press button
function before the set time expires;
the hood will adjust to speed 1. Press
button
3
Lights ON/OFF button
4
Speed timer button
5
Display
1 2
1 4
1 3
2
to deactivate this
1
to turn the hood off.
Speed timer button
Press button
the hood turns off once the set time expires.
The timer functions in the following way:
•
Speed 1 - 20 minutes (the number "1"
and a small flashing LED light appear
on the display)
•
Speed 2 - 15 minutes (the number "2"
and a small flashing LED light appear
on the display)
•
Speed 3 - 10 minutes (the number "3"
and a small flashing LED light appear
on the display)
•
High-speed - 5 minutes (the number
"4" and a small flashing LED light
1 4
appear on the display)
Press button
hood off while the speed timer is in function;
by pressing button
the set speed.
Saturation indicator of the grease filter
After 80 hours of operation, the display
shows alternately the set speed and the
letter "F".
Saturation indicator of the charcoal filter
After 320 hours of operation, the display
shows alternately the set speed and the
letter "C".
Reset of saturation indicator
In order to reset the saturation indicator,
switch on the hood then press and hold
button
1
for about 3 seconds.
Perform filter maintenance as
recommended in this manual.
In the event that both indicators of filter
saturation "F" and "C" start flashing,
proceed with the reset twice.
The saturation indicator of the charcoal
filter is not normally active and if the hood
is used in the recirculation mode, it must be
activated manually the first time.
Activation of the charcoal filter
saturation indicator:
Turn off the hood and simultaneously press
buttons
2
and
The letters "F" and "C" will flash on the
display for 2 seconds, to indicate successful
activation of the saturation indicator of the
charcoal filter.
4
to activate the speed timer;
1
or button
4
to turn the
2
, the hood returns to
3
for 3 seconds.
Werbung
Inhaltsverzeichnis
