MONALDI INOX Betriebsanleitung Handbuch Seite 11

INSTRUCTIONS FOR USE
1) Screw the spiral (9 - Fig. 1) down
onto the valve (8) and gun (1) using Teflon
or soft sealing liquid.
2) Release the pressure inside the tank
by opening the ball cock (6).
3) Unscrew and remove the loading plug
(4), pour the product into the instrument,
dilute it with water at the concentration
recommended by the manufacturer, check
the amount on the level indicator (3); then
close and screw down well.
4) Connect the compressed air pipe to
the quick connector (6a) until a pressure is
reached (max. 8 bar) and check it on the
pressure gauge (7).
Open the cock (8).
Use the spray gun (1) to spray the product
directly on the vehicle (Fig. 2) .
Leave the air pipe connected for all the time
it is used.
N.B.: Always use the liquid concentration
recommended by the manufacturer.
This wastes less product into the environ-
ment, consequently there is less pollution.
The recipient suffers less aggression from
chemical agents and lasts longer.
FIG. 2
instruction nebulizer inox
FIG. 1
11/24 rev. 0.00