Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Controlling the Walk Assist
Use the Walk Assist feature to easily take the bicycle
by the hand, for example when taking it out of
underground storage. Stand firmly next to the bike and
hold your hands on the handlebars. If a brake lever is
present, keep at least one hand on the brake where
the brake-circuit breaker (interruption of the motor
assistance) is located. This is generally is the left brake
lever. Keep the 'PLUS' button pressed while firmly
holding the handlebars. The engine will start after a few
seconds. Once you release the 'PLUS' button the Walk
Assist function switches itself off. The Walk Assist has a
speed of 6 km/h (no load).
Bicycle lights
Press the 'ON/OFF' button to turn on the bicycle lights.
Press 'ON/OFF' again to turn it off again.
USB connection
The USB connection on the back of the display can be
used to provide power to devices such as smartphones
and navigation devices. It can also be used when the
system is off, if the battery is still on the bike.
Resetting the Trip data
By pressing and holding the 'MINUS' button for two
seconds you can reset the trip distance. This also
resets the logged maximum speed and timer. If the trip
distance reaches the 500 km it will be automatically
reset.
Settings menu
By pressing and holding the 'SET' button for 2 seconds
you can open the settings menu. By pressing 'SET'
shortly you can switch between the different settings,
with the 'PLUS' and 'MINUS' buttons you can changes
the values. Leave the settings menu by holding 'SET'
button.
SET 1: Setting the Driving-mode
Please note: Option only availible on P-MN7 / P-MN360
With the 'PLUS' and 'MINUS' buttons you can adjust the
driving-mode. Not every cyclist is the same. One likes a
powerful support where someone else prefers an extra
high range. Therefore the display has 3 different driving
modes that influence the motorpower:
ECO:
Extra high range, less motorpower
NORMAL: Average range, average motorpower
POWER: Extra motorpower, lower range
Werbung
