Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SET 2: Setting the speedlimiter
Please note: Option only availible on P-RD9(s)
With the 'PLUS' and 'MINUS' you can adjust the
speedlimiter. With this you can limit the maximum
speed in which the motor provides power. This can be
handy if you prefer to drive on lower speeds.
SET 3: Setting the Tire-size
Set the correct tire-size for more exact information on
the screen. On the side of every tire you can find the
size. The pre-set sizes may deviate a little. This means
that the amount of driven kilometers has a maximum
deviation of 5%.
The default setting for your QWIC bike is:
28 inch
40-622 Circumference: 2205 mm*
SET 4: (Speed) Units
With the 'PLUS' and 'MINUS' buttons you can switch
between kilometers (per hour) and miles (per hour).
SET 6: Battery information
Please note: Option only availible on P-MN7 / P-MN360
With the 'PLUS' and 'MINUS' buttons you can see the
following information of the battery: The percentage of
the remaining battery-capacity, the total charging-cycli
and the actual battery voltage.
Error codes
It is possible that failures occur. If this happens, go to
the dealer as soon as possible so repairs can be carried
out quickly. The following codes can be displayed on
the display:
Error 1:
Problem with 3-phase control from the
controller
Error 2:
Problem with throttle connection (start-
detection)
Error 3:
Motorcable 3-phase wiring loose or defective
Error 4:
Motorcable Hall Sensor signal malfunction
(malfunction in motor or motorcable)
Error 5:
Malfunction in brake sensor(signal)
Error 6:
Battery voltage too low
Error 7:
Motor stalled
Error 8:
Malfunction in controller (signal)
Error 9:
Malfunction in display (signal)
Werbung
