FLORABEST H14335 Bedienungsanleitung Seite 12

Operation
note: The LC display
of the humidity
1
sensor changes automatically between
the soil moisture content (Fig. A), soil
temperature (Fig. B) and air temperature
displays (Fig. C).
note: The soil moisture content display
is influenced by the composition of the
soil and the organic material content and
can therefore fluctuate. The display should
therefore only be considered as a general
indicator and not as a source of precise
information.
note: If the soil is very coarse or porous,
then the soil moisture content may not be
displayed correctly as the soil sensor
5
may be in contact with air in certain circum-
stances. In this case, the displayed value
is less than the anticipated soil moisture
content.
note: The soil moisture content display
is updated every minute. Therefore you
should wait for one minute after watering
and then read the updated value. Insert
the humidity sensor deeply into the soil
and wait 10 minutes to allow the water
to percolate through the soil and reach
the soil sensor .
5
note: The temperature measurement
range of the humidity sensor is 0-50 °C.
Outside this range, the soil sensor (temper-
ature) may not always work properly.
11
12 GB/IE
®