Operation - Cotech Z1J-TD10-13E-UK Bedienungsanleitung

Operation

Chuck
1. The hammer drill is equipped with
a 13 mm keyless quick chuck.
2. Hold the rear collar of the chuck and twist
the front collar anticlockwise
until the jaws are wide enough apart
to allow the drill bit to enter.
3. Insert a drill bit or other tool.
4. Hold the rear collar of the chuck and twist
the front collar until the jaws lock onto
the tool or bit.
Warning: Do not try to tighten the chuck by holding the rear collar whilst starting
the drill; this could result in personal injury. Moreover, the chuck tightens better if
the two collars are gripped and tightened by hand.
Side handle
1. Screw the side handle anticlockwise
to undo it.
2. Fix the side handle in the desired
position. Set the depth stop if needed.
3. Screw the side handle clockwise to
lock both the handle and depth stop.
Power trigger
1. Plug the lead into a wall socket after
inserting a tool into the chuck and
tightening it.
2. Start the hammer drill by gently pulling
the power trigger (1), check that the tool
rotates in the correct direction. Release
the power trigger to stop the drill.
3. When the chuck is rotating,
the power trigger can be locked by
pressing the lock button (2) and releasing
the power trigger. To stop the drill, pull
the power trigger and then release it.
6