Inhaltsverzeichnis
Werbung
Intended Use
The stapler is intended for tacking of cardboard, insulating
material, fabric, foils, leather and similar materials on surfaces
of wood or materials similar to wood. The stapler is not suita-
ble for the attachment of wall and ceiling paneling.
The intended use also includes an operation following the
operating instructions. The operator is liable for any damage
caused by improper use.
Inserting Staples
Please keep in mind that staples must be suited to the material
they are used in. The harder the material is, the shorter the
staples should be.
1. Press the drawer (7) downwards and pull out
of the unit.
2. Insert the staples into the magazine with the
points facing down.
If you intend to drive nails, you can
place the strip of nails into the right and
the left side of the magazine.
3. Slide the drawer back into the unit and lock it into place.
Using
1. Press the stapler on the spot at which you intend to drive a
staple or a nail.
2. Press the trigger (1) until the stapler drives in the staple or
nail.
Adjusting the Impact Strength
Turn the impact strength regulator (2) counter clockwise in order
to reduce the impact strength and turn the regulator in clockwise
direction in order to increase the strength. For hard material
always select high impact strength.
Operation
9
Werbung
Inhaltsverzeichnis
