Setting Up Your Mppt; Safety Recommendations - Phocos MPPT100/30 Bedienungsanleitung

Setting up your MPPT

EN
The MPPT comes with an 8 pole DIP-switch, which can be used to set up your MPPT.
Note: DIP switches have to be in "ON" or "OFF" position only. The middle position is not allowed!!
DIP No.1,2,3 and 4 are for the use in the modular system(for details see MCU manual).
DIP No.5 and 6 are reserved for future functions.
DIP No. 7 is for battery type.
DIP No.8 is meant to choose between standalone or modular operation.
DIP NO.
5
6
7
8

Safety Recommendations

Batteries store a large amount of energy. Under no circumstances, never short-circuit a battery. We
recommend connecting a fuse (slow acting type, according to the nominal regulator current) directly
to the battery terminal.
Batteries can produce flammable gases. Avoid making sparks, or using fire or any open flame around
the battery. Make sure that the battery room is ventilated.
Avoid touching or short circuiting wires or terminals. Be aware that the voltages on specific terminals
or wires can be as much as 95V. Use isolated tools, stand on dry ground, and keep your hands dry.
Keep children away from batteries and the charge regulator.
Please observe the safety recommendations of the battery manufacturer. If in doubt, consult your dealer
or installer.
ON
OFF
1 2 3
Type
Reserved functions
Reserved functions
Battery type
Application
SAB
4 5 6 7 8
Switch position
-
+
-
+
-
+
-
+
11
+
-
Operation mode
---
---
---
---
Regular lead acid battery
GEL-type battery
Standalone
Modular system