General User Information; Electronic Control Setup - Whirlpool 3LCED9100 Installationsanleitung Für Den Professionellen

IMPORTANT
Electrostatic Discharge (ESD)
Sensitive Electronics
ESD is present everywhere. ESD may damage or weaken the
electronic control assembly. The new control assembly may
appear to work well after repair is finished, but failure may
occur at a later date due to ESD stress.
Use an anti-static wrist strap. Connect wrist strap to green
I
earth connection point or unpainted metal in the appliance.
Touch your finger repeatedly to a green earth connection point
or unpainted metal in the appliance.
Before removing the part from its package, touch the
I
anti-static bag to a green earth connection point or
unpainted metal in the appliance.
Avoid touching electronic parts or terminal contacts; handle
I
electronic control assembly by edges only.
When repackaging failed electronic control assembly in
I
anti-static bag, observe above instructions.

GENERAL USER INFORMATION

"out of order" showing in display
This condition indicates the dryer is inoperative. Diagnostic or failure
code will follow the scrolling message.
'0 Minutes' showing in display
This condition indicates the dryer cannot be operated until normal
operation is restored by opening and closing the door. If a door
switch fails, it must be replaced before normal operation can be
restored.
Cold Start (initial first use)
Dryer is programmed at the factory as follows:
45 minutes dry time.
I
Warm Start (after power failure)
A few seconds after power is restored, if a cycle was in progress
at the time of the power failure, 'RESELECT CYCLE' will flash
in the display. This is to indicate the need for a fabric setting
button to be pressed to restart dryer.
Dryer is pre-set for free cycle operation so it can be run without
payment.

ELECTRONIC CONTROL SETUP

-OR-
DISPLAY
After the dryer has been installed and plugged in, the display will
show '0 minutes.'
Once the dryer has been plugged in and the dryer door opened
and closed, the display will flash 'SELECT CYCLE'.
11