Troubleshooting - RUSTA 906512270101 Gebrauchsanweisung

THE TRANSDUCER
• In places with hard water, limescale deposits tend to form on the surface of the trans-
ducer. The transducer should then be cleaned with detergent.
• Apply detergent to the surface of the transducer. Fill the water tray where the trans-
ducer is situated full of water and allow to stand for 10–15 minutes.
• Clean with a brush until the deposits disappear.
• Clean twice with water.
• Warning! To avoid damage, do not clean or scrape the transducer with metal or other
rigid materials.
CASING AND WATER TANK EXTERIOR
• Wipe clean with a soft cloth and use a mild detergent to remove dirt.
STORAGE
• Empty the water in the tank and on the inside, remove any dirt, wipe off any moisture
and allow the machine to air.
• Make sure there is no water in the humidifier and put it back into the packaging.
• Store the packaging in a dry place.

TROUBLESHOOTING

If the humidifier does not work properly, check the following before having it serviced.
Problem Possible cause
Check the electrical socket
Check the power switch
No water vapour
No water in the tank
Too little water in the tank
New appliance
Steam smells
strange
Dirty water or old water in the tank
The tank is incorrectly positioned
Sound Too little water in the tank
Humidifier is on an uneven surface
Steam emitted
Space between nozzle and water tank
around the nozzle
Solution
Plug the appliance in
Turn the power switch on
Add water
Fill the tank so it is full
Remove the tank lid and place the
water tank in a cool, dry place for 12
hours
Clean the water tank. Fill with clean
water
Adjust the position of the tank
Fill with water
Place it on an even surface or ground
Dip the nozzle in water and use it
again
5