Blaupunkt RTSA 752002 Anleitung Seite 19

OPERATING INSTRUCTIONS
Before starting work:
• Check that the trigger switches and the safety switch should move freely without forcing and return automatically and rapidly
back to their neutral position;
• Check that the cooling air vents are not obstructed;
• Check that hand grips and protection devices are clean and dry, correctly mounted and well fastened to the tool.
• Check that the tool is not showing signs of wear or damage due to knocks or other causes.
• Check that the battery is in good working condition and there are no signs of damage.
• Never use the tool with a damaged or worn battery;
• Charge the battery according to the instructions in the charging section.
Trimming And Edging
• For the most effective grass trimming ensure the tool is operating at full speed and then use slow shallow sweeps of the line,
do not overload the tool by cutting too fast.
• Make sure that the work area is free of rock, debris, objects.
• Start the tool and allow it to reach full speed before cutting.
• Cut the grass by moving the tool from right to left and proceed slowly keeping the trimmer head at an angle of about 30º.
• Light cuts are better than heavy cuts as they allow the cut grass to fall away from the spool preventing the grass from clogging
the spool.
• Long grass should be cut in layers always beginning from the top.
• Do not cut damp or wet grass. Avoid wearing the line out quickly by knocking against hard objects (stones, walls, etc).
• After finishing the cutting operation, keep the head close to ground level, release the trigger switch and allow the motor to
stop completely. Place the trimmer on the ground, remove the battery.
• For edging, rotate the motor head.
• Use the wheel on the head for consistent control
• Position the trimmer so that the line hangs over the edge of your lawn and does not make contact with the soil.
• Walk forwards and follow the edge of your lawn.
Note: Periodically clean out the grass between the spool and the rim of the guard to prevent the tool from vibrating.
Product Specifications
Motor
No load speed
Cutting width
Line diameter
Sound Pressure Level
Sound Power Level
Vibration Level
18V DC
7200 RPM
250 & 300mm
1.65mm
LpA 85dB(A)
LWA 96dB(A)
3.5m/s2