Blaupunkt RTSA 752002 Anleitung Seite 18

TOOL SPECIFIC SAFETY INSTRUCTIONS
• When using the tool, always use caution and take on a firm and well-balanced position.
• Where possible, avoid working on wet, slippery ground or in any case on uneven or steep ground that does not guarantee
stability for the operator.
• Never run, but walk carefully paying attention to the lay of the land and any eventual obstacles.
• Assess the potential risks of the area you are cutting and take all necessary precautions to ensure your own safety, especially
on slopes or on bumpy, slippery or unstable ground.
• Do not use the tool if you are unable to hold it with both hands or keep it steady on your legs while working.
ASSEMBLY
Warning! To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the product
when assembling parts.
Attaching The Guard
• Invert the grass trimmer/edger to access the trimmer head. Using a Phillips head screwdriver, remove the pre-installed screw
from the trimmer head.
• Place the guard on to the trimmer head so that the large part of the guard sits to the rear, (Fig.3).
• Align the screw hole on the guard with the screw hole on the trimmer head. Insert the screw into the trimmer head, fastening
the guard in place, (Fig.4).
• Remove the protective tape from the line cutting blade, (Fig.5).
Adjusting The Front Handle
• To avoid injury, adjust the front handle for optimum control and balance.
• The front handle can be moved either up and down the shaft, forward and backwards or rotated 360º around the shaft. To find
your optimum desired position unlock the quick release locking lever by pulling outwards, (Fig.6).
• Once you have the desired position relock the front handle locking lever by pushing inwards.
Adjusting The Shaft Length
• Loosen the lower part of the centre collar (Fig.7). This will allow the lower part of the shaft to be extended or retracted.
• When the shaft is at a comfortable length, retighten the collar.
Rotating The Shaft
• The shaft can be rotated to the 0 or 180º position for trimming and edging operations.
• Pull the upper part of the centre collar (Fig.8). This will allow the motor to be rotated between the 0 or 180º position.
• Note: The head will only lock in the 0 or 180º position.
Rotating The Trimmer Head
• The trimmer head can be rotated to the 0 or 90º position for trimming and edging operations.
• Press the Edger adjustment button, Fig.9, and the trimmer head will spring around 90º. Make sure it is locked into position.
• To move the trimmer head back simply press the edger adjustment button again and rotate back to its original position.
Extending The Line
• To extend the line press the spool line extension button on the spool, (Fig.10)
• Warning! To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the
product when extending the line.
Adjusting The Line Cutting Blade
• The cutting line can be set at two lengths (250 & 300mm).
• To adjust the line cutting blade turn the line cutting blade adjustment dial by pushing down and rotating 180º (Fig. 11)