Important Safety Instructions; To Avoid Fire Or Personal Injury - TESTEC TT-CC 770 Bedienungsanleitung

AC/DC Oscilloscope Current Probes TT-CC Series

3. Important Safety Instructions

Please read the following safety instructions thoroughly to avoid
personal injury and prevent damage to this product or any products
connected to it. Use this product only as specified.
Only qualified personnel should perform service procedures.
3.1 Avoid Fire or Personal Injury
Connect and disconnect properly!
measurement instrument before connecting the probe to the circuit under test.
Disconnect the probe input and the probe ground from the circuit under test
before disconnecting the probe from the measurement instrument.
Observe all terminal ratings!
rating and markings on the product. Consult the instruction manual for further
ratings information before making connections to the product.
Replace batteries properly!
rating specified.
Do not operate without covers!
covers or panels.
Avoid exposed circuitry!
components when power is present.
Do not operate with suspected failures!
this product, have it inspected by qualified service personnel.
Do not operate under wet or damp conditions!
Do Not Operate in an explosive atmosphere!
Keep product surfaces clean and dry.
Connect the probe output to the
To avoid fire or shock hazard, observe all
Replace batteries only with the proper type and
Do not operate this product without the
Do not touch exposed connections and
If you suspect there is damage to
E-4 English