ZyXEL N4100 Kurzanleitung Seite 5

1. LAN 1~4: Use Ethernet cables to connect the LAN ports to
computers, switches and a statement printer (optional).
2. WAN: Connect your broadband modem to this port with the Ethernet
cable that came with your modem.
3. Attach the included antennas to the N4100. The antennas should be
perpendicular to the ground and parallel to each other.
4. POWER: Connect the N4100's included power adaptor to the
N4100's power socket.
Check the LEDs (Lights)
Look at the LEDs (lights) on the front panel of the N4100.
• The PWR light (LED) turns on.
• The WAN or LAN light turns on if its corresponding port is properly
connected. The lights blink when the N4100 is sending or receiving
data through the corresponding port.
• The WLAN light stays green when the wireless LAN is enabled. It
blinks when the N4100 is sending/receiving data through the
wireless LAN.
• The SYS light turns on once the N4100 is ready.
ENGLISH
5