Troubleshooting Guide; Specifications - Cotech E0003HA-B3V-YX Bedienungsanleitung

Synchronising the sensor with a weather station/thermometer
(main unit)
1. Press and hold in [ CH/▲ ] on the main unit (sold separately) until the signal icon
begins to flash. The main unit will begin searching for the outdoor sensor.
2. Press [ CH/▲ ] repeatedly until the desired channel appears on the display of
the main unit.
- Choose CH 1 if channel 1 has been selected on the temperature sensor.
- Choose CH 2 if channel 2 has been selected on the temperature sensor.
- Choose CH 3 if channel 3 has been selected on the temperature sensor.
3. After a short moment, the readings from the sensor will appear on the display of
the main unit.
• The main unit should receive data from the sensor and display the temperature
within 3 minutes of the batteries having been inserted in both devices.
• Refer to the Troubleshooting section if there is a problem.
Troubleshooting guide
Nothing appears •
on the display of
the main unit.
Temperature •
from outdoor
sensor not •
displayed.
•
•
•
•
Displayed •
temperature is •
incorrect.

Specifications

Batteries 2 × AAA/LR03 (sold separately)
Update interval 60 seconds
433 MHz
Frequency
Range 30 m
Size 38 × 100 × 18 mm
30 g
Weight
Check the batteries in the main unit and sensor/s.
Check that the distance between the thermometer and
sensor does not exceed 30 m.
Make sure that the devices are located at least 2 m from
monitors and TV sets.
Avoid placing the devices on or close to window frames
made of metal.
Avoid using electronic devices such as loudspeakers
which operate at the same frequency (433 MHz), close to
the devices.
Check the batteries in the thermometer and any connected
sensors.
Remove the batteries, wait awhile and then reinsert them.
Remove the batteries, wait awhile and then reinsert them.
Make sure that the devices are not affected by heat sources
or air-conditioning units and such.
5