Installation - Cotech E0003HA-B3V-YX Bedienungsanleitung

Buttons and functions
1. LED indicator (flashes
when data is being sent
to the thermometer unit)
2. Wall bracket
3. Channel selector
4. Battery compartment

Installation

Batteries and channel selection
1. Slide the battery cover downwards in the direction of the arrow to access
the battery compartment.
2. Insert 2 × AAA/LR03 batteries (sold separately) observing the polarity markings in
the battery compartment.
3. Channel selection:
- Set the channel selector to position 1 if only one sensor is to be used with your
thermometer/weather station.
- Set the channel selector to position 2 if you are already using one sensor with
your thermometer/weather station.
- Set the channel selector to position 3 if you are already using two sensors with
your thermometer/weather station.
4. Click the battery cover back into place.
Placement
1. Place the sensor in a location that is protected from direct sunlight and rain.
2. Mount the sensor at least 2.5 m above ground, if possible.
3. Screw a screw into a suitable mounting surface and hang the sensor on it using
the wall bracket (2).
2
1
3
4
4