Troubleshooting - Renkforce 1398138 Bedienungsanleitung

• When the microphone transmitter is turned on and the pairing symbol
station's LCD display, briefly press the power button
transmitter with the receiver on the corresponding channel. The transmitter and receiver will attempt to
pair with each other. Both LCD displays will show the flashing pairing symbol.
• If the pairing attempt was successful, the corresponding identification symbol
channel will be shown on the receiver station's LCD display. The
audio channel then disappears. Once they have been paired, the microphones display their current
transmitter frequency on the corresponding LCD display (16). When they have been paired, the receiver
station and the wireless microphone will show the same frequency and wireless channel number. The
microphone then transmits signals via this paired channel.
• If you wish to use a second microphone, repeat the above steps for the second audio channel (A or B).
• The paired microphone(s) can now be used.
Please note that you cannot use two microphones on different wireless frequencies of the
same audio channel. If there are other wireless devices in the vicinity of the microphones,
ensure that these are transmitting on another frequency.
• Turn on the connected audio device.
• Set the desired volume using the VOLUME.A (5) and VOLUME.B (1) volume controls on the receiver
station and the volume control on the connected audio device.
• Repeat the pairing process for each of the wireless channels (up to 2 x 16 wireless channels).
• The paired wireless microphone transmits the recorded sound to the receiver station. The receiver
station then forwards the signals to the connected audio device. The transmitter has a maximum range
of 30 m with no obstructions.
• Switch off the receiver station after use by pressing the POWER toggle switch (6) (set to 0).
You can also pair the microphone with the receiver station by listening to the connected audio
device, e.g. when it is dark or when the visibility is poor. To do so, turn on the receiver station
and the connected devices and carefully move the volume control upwards slightly for the
corresponding audio channel (A or B) until you hear a sound coming from the loudspeaker. A
beep is played at regular intervals during the pairing process. This switches to a constant tone
when pairing is successfully completed.

13. Troubleshooting

This wireless microphone set is built according to the latest technology and is safe to operate. However,
problems and malfunctions may still occur. For this reason, the following section provides an explanation
on how to rectify possible malfunctions.
(18) on the wireless microphone twice to pair the
symbol for the corresponding
is flashing on the receiver
or for the audio
29