Frequently Asked Questions (Faq); Technical Data - Philips SHD8900/00 Bedienungsanleitung

4 LED lamp indications
Situation Transmitter
LED Blue
Connection established On
Charging
0-50% full Off
> 50% full Off
100% full Off
Low battery indicator On
Searching Blinking, slow motion Off
5 Sound indications
Situation Sound signal
When battery level is low One "Beep" per minute (around 5 beeps)
Before battery totally goes out "Beep Beep"
Turn the volume to Max/ Alert tone "Beep"
Min level
6 Technical data
Transmitter
System: Radio Frequency (RF)
Modulation: DMQ PSK
Carrier Frequency: 2400M - 2483.5MHz
Channels: 3 (auto-switching)
Radiated Output Power: 30mW
Effective Transmission Range: Approx. 30 meters
(depending on ambient conditions)
Input Level: 800mV (0 dB)
2V (-8 dB)
Power requirements: DC 6V
(from the supplied AC power adaptor)
Headphone
Playback frequency range: 20 - 20,000 Hz
S/N Ratio: 88dB Nominal
Distortion: 0.5% THD
Channel Separation: ≥60dB
Power Requirements: Rechargeable Ni-MH batteries (supplied)
or commercially available (size AAA) dry batteries
Operating time: ~ up to 10 hours (actual result may vary)
4
Headphones
Green Blue
Off On
Blinking, fast motion Off
Blinking, slow motion Off
On Off
Off Blinking, fast motion
Blinking, slow motion
7 Frequently asked questions (FAQ)
Problem Possible cause
1. Headphone fails 1.1 No battery installed
to charge
1.2 W rong battery orientation
1.3 No power supply
to transmitter
1.4 Alkaline battery or
non-short sleeve
battery is used
1.5 Charging pin of the docking Refer to picture E to dock the
station not in contact
with the metal plate of
the headphone
1.6 Wrong headphone
orientation when placed
onto the charging dock
2. No sound/ 2.1 Set up not yet completed
distorted sound
2.2 Not set up properly
2.3 Battery power running low
2.4 Audio source not
connected
2.5 Audio source is off
2.6 Audio source level too low
2.7 Audio source level too high
2.8 Volume level set too low
2.9 Receiver too far away
from transmitter
For further product support, please refer to www.philips.com/welcome
Solution
Refer to picture C to install or
replace batteries.
Reposition the batteries according to
the polarity symbol.
Refer to picture D to make sure the
docking station is connected to the local
mains power.
Only use Philips' rechargeable shortened
sleeve NiMH batteries for charging.
headphone in place, and make
sure the CHARGE INDICATOR light
on.
Reposition the headphone with correct
orientation.
Refer to possible causes from FAQ
1.1, 1.2 & 1.3.
Refer to picture F to ensure audio
cable is connected to the AUDIO OUT
of the device.
Refer to picture E to recharge the
headphone.
Refer to picture F to connect the audio
source.
Turn on your audio source.
Adjust the volume level of audio device
to higher and non-distorted level. If MP3
player or 3.5mm triport socket output is
used, switch ATT to 0dB.
Adjust the output level to lower and
non-distorted level. If HiFi, DVD or RCA
output is used, switch ATT to -8dB.
Adjust the volume level of your audio
source or headphone.
Note: the volume is not adjustable for
some of the audio source.
Move closer for reception.
5