Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
Press the SET button, hold it down and at the
same time press a device button, e.g. TV, until
the red lamp comes on.
4.
Then enter one of selected three-digit codes
5.
When the first and second number buttons are
pressed the lamp goes out briefly; when the third
is pressed it stays out.
6.
Try out the functions. If everything is okay, you
can set the remote control as described in steps
1 to 5 for other devices. If it is not okay, try
another code for the same brand.
The letters on the device buttons TV, SAT, AUX are for your
orientation only. You can set each type of device under any
of the buttons.
If you do not find a suitable code for a device, look for it
using the code search.
Code search
To control a TV:
1.
Switch on a program on your TV (on the TV
itself or with the original remote control).
2.
Press the SET button, hold it down and at the
same time press a device button, e.g. TV, until
the red lamp comes on.
3.
Then press the SET button again briefly, the
lamp starts to blink.
4.
Press the PWR button approx. every 2 seconds.
5.
When the TV switches itself off, briefly press the
device button (TV) to store the code found.
6.
The lamp goes out and the search is ended.
7.
Try out the functions. If everything is okay, you
can set the remote control as described in steps
1 to 6 for other devices. Then press the device
buttons SAT, or AUX instead of TV*). If it is not
okay, continue searching as described in 1 to 6.
Automatic code search
To control a TV:
1.
Switch on a program on your TV (on the TV
itself or with the original remote control).
Vivanco GmbH, Ewige Weide 15, D-22926 Ahrensburg, Tel:+49(0)
4102231235, Fax: +49(0)4102 31444, e-Mail:
hotline@vivanco.de
2
Werbung
