Charge Battery; Rotation Direction; Adjustments - Hornbach PE-AS18Li Bedienungsanleitung

CHARGE BATTERY

1 Slide the battery seat onto the bat-
tery 9. Plug in the battery adaptor and
check its LED:
Green
Before charging
Red
During charging
Green Fully charged
ATTACH BATTERY
1 Slide the drill driver onto the battery 9.
Caution! Only use the provided bat-
tery with the drill driver.
FIT BIT
1 Open the chuck ring 2
into the chuck.
Caution! Before changing bits, cen-
tre the rotation direction switch, in
order to lock the drill driver.
FIT DRILL
1 Open the chuck ring 2
into the chuck and set the torque
to drill .
Caution! Before changing drills,
centre the rotation direction switch,
in order to lock the drill driver.

ROTATION DIRECTION

1 To drive in screws or drill, set the rota-
tion direction switch
Caution! If the drill driver is not in
use, centre the rotation direction
switch, in order to lock the drill driver.
2
2
until the bit fits 2
until the drill fits 2
ring 7
2
8 to
.
Once the battery 9 is fully charged,
press the battery release
slide it off the battery seat.
To release the battery 9, press the bat-
tery release switch 5 and slide it off the
drill driver.
Fit the bit into the chuck 1
the chuck ring 2 securely. Set the de-
sired torque at the torque ring 7.
Remove the bit by opening the chuck
ring 2.
Fit the drill into the chuck 1
the chuck ring 2 securely.
Remove the drill by opening the chuck
ring 2.
To loosen screws, set the rotation di-
rection switch 8 to
.
switch 5 and
and tighten
and tighten
EN 105