Power Supply; Changing The Batteries - Kaba Mauer Code-Combi K Bedienungsanleitung

GB
5 Power supply
The lock is powered by means of a 9-volt block battery. We recommend using an alkaline/
manganese battery with reduced heavy metal content
When changing the battery, please dispose of old batteries in an environmentally friendly man-
ner using recycling/collecting boxes. Batteries should never be thrown on the fire, into water or
thrown away with normal household waste.
Insufficient power supply
1) After pressing ON
2) Replace battery without delay
Low voltage is shown if the red LED flashes 10 times after the ON button is pressed. There is
still sufficient energy for opening approximately 50 times, but no further programming se-
quences should be carried out.
When low voltage is indicated, please change the battery immediately. If the low battery signal
is ignored for a long period the number of possible opening cycles may be reduced due to the
battery's automatic discharge.
5.1 Changing the batteries
Press the catch on the top edge of the battery cover with a screwdriver and lever of battery lid.
Pull the battery out carefully until the battery clip is visible. Release the battery from the clip
and replace. Re-engage the lid. Please ensure that the cable is not damaged.
Diagram 2: Battery case
Page 13 82021 Code-Combi K
10 x
Kaba Mauer GmbH