Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SELF-LEARNING PROCEDURE
When one of 2 supplied transponders is lost, it is
necessary to execute the SELF-LEARNING proce-
dure to learn a new TRANSPONDER KEY. Follow
this steps for activating the procedure.
TRANSPONDER SELF-LEARNING
a) Deactivate the immobiliser by TRANSPONDER.
b ) Turn ignition key to ON position.
c) Move one original TRANSPONDER to the reader,
within 10 seconds.
d )Reading the TRANSPONDER, turn OFF the ignition
switch.
e) Move away the TRANSPONDER from the reader.
f) Check if the L.E.D. is steady ON, as indication of the
starting of the learning procedure.
g)Within 10" the LED remains ON, move a NEW
TRANSPONDERS to the reader , followed by the old
ones (if available). Each transponder learning is
signalled by a short pause of the L.E.D.
f ) When the 10" from the last
elapsed, the immobiliser exits from the procedure
and displays the EMERGENCY CODE (PIN CODE)
via L.E.D. If no one TRANSPONDER has been
learnt, the LED will display the previous PIN
CODE.
h )After having note the PIN CODE on a personal card,
verify that the two coded TRANSPONDERS operate;
otherwise, repeat the above steps.
You can self-learn a amaximum of 4 TRANSPONDERS.
After the abov e operat ions, the lost
transponders become useless.
How to know your "EMERGENCY CODE"
(PIN CODE)
To display the PIN CODE, activate the self-learning
procedure and wait 10 seconds for switching OFF the
LED. The immobiliser will use the Red LED for displaying
5 sequences of flashes that will correspond to 5
numbers. The following table shows an example of a
PIN CODE and the corresponding LED flashes.
Per i numeri
n° di lampeggi corrispondenti
5
n° 5 lampeggi consecutivi del LED
n° 6 lampeggi consecutivi del LED
6
n° 10 lampeggi consecutivi del LED
0
5
n° 5 lampeggi consecutivi del LED
n° 4 lampeggi consecutivi del LED.
4
On the above example, the PIN CODE to note on the
personal card will be 5 6 0 5 4.
Write down the PIN CODE after each self-learning
procedure, as the CODE may change after every
learning procedure. Keep always in the pocket the
personal card, with the PIN CODE.
IS261T-D.p65
If all the TRANSPONDERS do not work correctly or
have been lost, to disarm the immobiliser you must
insert the "PIN CODE" as follows:
1) With the immobiliser ON, turn ON the ignition
2) The RED LED is steady ON for 10".
3)
4) Now on the LED will flash and the immobiliser is
learning
are
EXAMPLE: the code to be inserted is 5 6 0 5 4 . Wait 5 flashes
for the first digit. After the fifth flash has been completed and
the LED has turned OFF, immediately turn ON the ignition key
for 1". After a pause, the LED will flash the next digit of the
EMERGENCY CODE ; 6 in this example. For the 0 digit, the
flashes to be completed on the LED are 10. Continue until all
the digits have been displayed.
If the inserted CODE is correct, the immobiliser will
disarm itself and automatically will enter into the "SELF-
LEARNING PROCEDURE", signalling this condition by LED ON
for 10" . After that, if the learning procedure will not open, the
LED will remain OFF, without displaying the PIN CODE.
If the inserted CODE is wrong, the immobiliser will
remain ON.
Pausa di 2 sec.
Pausa di 2 sec.
Pausa di 2 sec.
Pausa di 2 sec.
Pausa di 2 sec.
4
HOW TO DISARM THE IMMOBILISER
USING THE "PIN CODE"
key.
When the RED LED switches OFF again, you have
few seconds for turning OFF the ignition key.
Otherwise, if You leave the ignition key to ON
position, the LED will flash ON and OFF alterna-
tively.
ready to accept the PIN CODE. If not interrupted,
the LED will flash 11 times. Turn ON for 1 second
the ignition key after the LED have displayed
the flashes corresponding to each digit of the PIN
CODE, red on personal card from left to right. For
better understanding, see the following
TURN ON THE IGNITION FOR 1 SEC.
5
1
2
3
4
6
TURN ON THE IGNITION FOR 1 SEC.
1
2
3
4
5
6
TURN ON THE IGNITION FOR 1 SEC.
1
2
3
4
5
6
TURN ON THE IGNITION FOR 1 SEC.
5
1
2
3
4
6
TURN ON THE IGNITION FOR 1 SEC.
1
2
3
4
5
6
CODE ?
CORRECT
IMMOBILISER DEACTIVATED
INCORRECT
IMMOBILISER STILL ACTIVATED
15/10/2014, 13.55
7
8
9
10
2" PAUSE
7
8
9
10
2" PAUSE
10
7
8
9
2" PAUSE
7
8
9
10
2" PAUSE
7
8
9
10
2" PAUSE
4
Werbung
