VOLTCRAFT 4500PRO Bedienungsanleitung Seite 33

e) Overload setting:
1. Press SET button once. The "W" value (Watt) starts flashing (fig. 27).
2. Use or buttons to set the max. current at which the device should activate an overload
alarm and press SET to confirm. Set each digit separately.
fig. 25
The purpose of the OVERLOAD function is to protect the connected household electrical appliance
from damage due to power overload. If the set alarm limit will be exceeded during operation of the
connected appliance, a buzzer tone will sound and "OVERLOAD" will be flashing in the display. Turn
off the connected appliance and disconnect it from the mains supply if necessary for overload and
hence for safety reasons.
Press button to switch to the area for deleting user settings "CLR settings".
Press button a second time to skip this area if you do not wish to change user settings.
f) CLR settings:
Two functions are available in this area:
1) „CLr ALL dAtA":
2) „CLr USEr SEt":
1. Press SET button once. The display will show "CLr" (fig. 28).
2. Press SET button one more time. The display will show "CLr ALL dAtA" (fig. 29).
3. Press or buttons. The display will show "CLr USEr Set" (fig. 30).
4. Press and hold F button (4) for approx. 3 seconds. The following set values will be deleted:
electricity rate, standby power, GHG/CO
5. Press or buttons. The display will show "CLr ALL dAtA". Press and hold F button for approx.
3 seconds. Following values will be deleted:
kWh, energy costs, saved time, greenhouse gas/CO
fig. 26
All data will be deleted and all settings will be reset to the default values.
All user settings will be deleted.
fig. 27
, max. power.
2
, max. Watts and Ampere values
2
33