Herunterladen Inhalt Inhalt Diese Seite drucken

Power Supply; Setting Time; Radio Operation; Programmed Play - elta 4258MP3 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
02- 4258 GB
12/12/06
3:55 PM

POWER SUPPLY

AC POWER :
230v~50Hz
DC POWER :
9V battery type (not including) for clock back-up system only.
Subject battery should be replaced every 6 months.
1. Insert AC power cord into a AC socket.
2. Connect 9V battery inside battery compartment.
3. Press "CD/RADIO ON" BUTTON for power on operating.

SETTING TIME

1. Press "CD/RADIO ON" BUTTON for power on operating.
2. Press & hold CLOCK BUTTON.
At same time press HR or MIN to adjust time of hour & minute.
3. Release CLOCK BUTTON to store your setting in memory.

RADIO OPERATION

1. Press "CD/RADIO ON" BUTTON for power on operating.
2. Slide the FUNCTION / BAND SWITCH to AM or FM position.
3. Adjust VOLUME CONTROL BUTTON to desired level.
4. Turn TUNING BUTTON to select your desired radio station.
5. To stop listening radio, press SNOOZE BUTTON for power off.
NOTE:
For FM reception there is a FM Antenna on rear of unit.
Extend antenna and move it around to obtain to best reception.
CD/MP3 OPERATION
How to play CD/MP3
1. Press "CD/RADIO" BUTTON for power on operating.
2. Slide FUNCTION SWITCH to CD position.
3. Press OPEN/CLOSE BUTTON & load your disc, then close CD door.
4. Press PLAY/PAUSE BUTTON to start listening from first track.
When all tracks on CD/MP3 have been played, this unit will automatically stop.
5. Adjust level of sound by using VOLUME CONTROL BUTTON.
6. To stop listening to CD/MP3, press STOP BUTTON or press SNOOZE BUTTON for power off.
How to use PAUSE & SKIP BUTTON
1. Start playing CD/MP3 as described previously.
2. Press PLAY/PAUSE BUTTON to pause current track.
Press PLAY/PAUSE BUTTON again to continue playing.
3. Press SKIP + BUTTON once to advance one track.
4. Press SKIP - BUTTON to skip to the previous track.

PROGRAMMED PLAY

This function allows you to preset order in which a series of tracks will be played.
1. Follow procedures 1 to 3 in CD/MP3 OPERATION.
2. Press PROG.SET BUTTON, display will show "01" standby for programmed.
3. Press SKIP + or – BUTTON select your desire track.
4. Display will show "02" for continuous programmed.
Then repeat above procedures 3.
08.
Page 08

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis