Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
SET POINTS
press (SET)
Set point OUT1
adjust with
confirm with (SET)
Reset point OUT1
adjust with
confirm with (SET)
Set point OUT2
adjust with
confirm with (SET)
Reset point OUT2
adjust with
confirm with (SET)
****
SET
Mastercode 1
SET
SET
SET
Mastercode 2
– 33D is not coded: Menu function „SET
CODE" can be deleted/activated.
– 33D is coded: Code can be deleted.
Menu selection and confirmation
SET
of settings
Browsing within menu and
increasing of values
Browsing within menu and re-
ducing of values
*
no = output signal at atmosphere (0 bar) = 0 V
**
nc = output signal at atmosphere (0 bar) = +U
*** Variation 33D for vacuum and with analogue signal 4 to 20 mA (0863042 and 0863046) can be programmed
as follows:
a) 4 to 20 mA adapted to range
b) 4 to 20 mA adapted to range
OPERATING DISPLAY
Indication of system pressure
Setup-Menu
press (SET) > 4 sec.
Set OUT1
select with (SET)
configuration of output 1
Set MODE
select with (SET)
on TIME
select with (SET)
adjust switch on delay with
off TIME
select with (SET)
adjust switch on delay with
END MENÜ
back to Setup-MENU
Set OUT2 ***
select with (SET)
configuration of output 2
Set MODE
select with (SET)
on TIME
select with (SET)
adjust switch on delay with
off TIME
select with (SET)
adjust switch on delay with
END MENU
back to Setup-MENU
Set UNIT
select with (SET)
select (BAR, PSI, MPA) with
Set Filter
select with (SET)
pressure peak damping with
Set CODE
Access protection
determine by pressing 5 buttons of your choice
Clear CODE
select with (SET)
delete access protection
END MENÜ
select with (SET)
back to operating display
B
-1 to +1 bar (0 bar = 12 mA)
0 to +1 bar (0 bar = 4 mA)
10
System Configuration MENU
+
during power-on procedure
33D INFO
select with (SET)
Series and Software-Release No.
Set LIGHT
select with (SET)
Display illumination on/off
Set ZERO
select with (SET)
Zero point suppression
no Code ****
select with (SET)
delete with Mastercode 1 and 2
END MENÜ
select with (SET)
back to Operating Display
Set MODE
select with (SET)
no *
OUT 1/2 Standard Mode
confirm n. o. with (SET)
next step with
nc **
OUT 1/2 Standard Mode
confirm n. c. with (SET)
next step with
no *
OUT 1/2 Hysterese Mode
confirm n. o. with (SET)
next step with
nc **
OUT 1/2 Hysterese Mode
confirm n. c. with (SET)
next step with
no *
OUT 1/2 Windows Mode
confirm n. o. with (SET)
next step with
nc **
OUT 1/2 Windows Mode
confirm n. c. with (SET)
next step with
7503442.99.10.01
Werbung
